Tel 089 890454 -- Fax 089 8422324
Cerca in dettaglio
Italiano  English  
Il carrello è vuoto

Prodotto 5/39

Precedente
Categoria
Successivo

AUDIO TECHNICA AT 3032-Microfono omnidirezionale condensatore

178.48EUR
  • Peso spedizione: 0.3kg.
  • Disponibilità in magazzino: In arrivo
  • Prodotto da: Audio Technica


caratteristiche tecniche:

The low-profile AT3032 omnidirectional condenser recording mic is outstanding for piano, acoustic guitar, and other acoustic instruments. Known for its flat, extended frequency response and wide dynamic range, the AT3032 handles high SPLs with ease. Its low-mass diaphragm improves transient response, increases response bandwidth and reduces handling and mechanical noise transfer. Its low self-noise (16 dB SPL) is perfectly suited for the most sophisticated recording equipment.

  • Outstanding performance and versatility
  • High max SPL and wide dynamic range
  • Omnidirectional polar pattern preserves “sound” of the recording location, delivers flat response and freedom from proximity effect
  • Low self-noise (16 dB SPL) – perfectly suited for today's most sophisticated digital recording equipment
  • Flat, extended frequency response
  • Lo-cut switch (80 Hz, 12 dB/octave) and 10 dB pad
 

 

 SPECIFICATIONS

 
ELEMENTFixed-charge back plate, permanently polarized condenser
POLAR PATTERNOmnidirectional
FREQUENCY RESPONSE30-20,000 Hz
LOW FREQUENCY ROLL-OFF80 Hz, 12 dB/octave
OPEN CIRCUIT SENSITIVITY-34 dB (19.9 mV) re 1V at 1 Pa
IMPEDANCE250 ohms
MAXIMUM INPUT SOUND LEVEL148 dB SPL, 1 kHz at 1% T.H.D.;
158 dB SPL with 10 dB pad (nominal)
NOISE16 dB SPL
DYNAMIC RANGE (typical)132 dB, 1 kHz at Max SPL
SIGNAL-TO-NOISE RATIO78 dB, 1 kHz at 1 Pa
PHANTOM POWER REQUIREMENTS11-52V DC, 3 mA typical
SWITCHESFlat, roll-off;
10 dB pad (nominal)
WEIGHT4.1 oz (116 g)
DIMENSIONS5.67" (144.0 mm) long,
0.83" (21.0 mm) maximum diameter
OUTPUT CONNECTORIntegral 3-pin XLRM-type
ACCESSORIES FURNISHEDAT8405a stand clamp for 5/8"-27 threaded stands; AT8159 windscreen; soft protective pouch
AUDIO-TECHNICA CASE STYLES1
  


SPECIFICATIONS GRAPHS

 
Click on the chart to view the larger image
POLAR PATTERNPOLAR PATTERN
FREQUENCY RESPONSEFREQUENCY RESPONSE
  

CONDITIONS

Specifications and product details are subject to change without notice.

Definitions/explanations for technical terms will be found in a large Glossary on this site. Links have not been included within the text on most pages, to keep them as readable as possible; but a Glossary button appears in the Navigation Bar at the top of each page.

Microphone Conditions (Additional comments)


Open Circuit Sensitivity At 1 kHz, with 1 Pa (Pascal) = 94dB sound pressure level (SPL), measured at diaphragm. Stated in dB re 1 volt, and in millivolts.

Noise, typical A-weighted, using Audio Precision System One measurement system.

Weight Stated for the microphone only, without accessories, and without attached cable/power module, if applicable.

Frequency Response (Graph) Shows mic output versus frequency with a constant sound input level from a source 0.5 meters from the diaphragm. Each vertical division in the graph is 10dB. A dashed line, if present, shows the effect of a low-roll-off (hi-pass) function.

Polar Pattern (Graph) Shows mic output versus angular direction of the sound source, with a constant sound input level at 1 kHz, at a constant distance from the diaphragm. Zero degrees (0°) is the "front" of the mic. Each circular division in the graph is 5 dB, beginning from the 0° point and counting inward.

Additional Information Profile pages for some products provide links to additional information, such as further specifications, operating instructions, product reviews, etc. These may be in various forms, such as text, graphics and pdf files.

Related Models Some profile pages provide links to other models of a most-similar or closely related type or function that may also be of interest.


Headphone/Headset Conditions (Additional comments)


Headphone Sensitivity Input of 1 milliwatt at 1 kHz into rated impedance; output in dB SPL, using a Brüel & Kjaer 4153 coupler.

Maximum Input Power At 1 kHz into rated impedance.

Boom Mic Sensitivity Open circuit, at 1 kHz, with 1 Pa (Pascal) = 94dB sound pressure level (SPL), measured at diaphragm. Stated in dB re 1 volt, and in millivolts.

Additional Information Profile pages for some products provide links to additional information, such as further specifications, operating instructions, product reviews, etc. These may be in various forms, such as text, graphics and pdf files.

Related Models Some profile pages provide links to other models of a most-similar or closely related type or function that may also be of interest.

 

AT3032 Specification Sheet (PDF 94.89 KB)
- 30 Series Brochure (PDF 313.84 KB)
   

Richiedi Info Disponibilità

In arrivo   In Arrivo



Dati a cura del produttore/fornitore.
I prezzi sono da intendersi IVA inclusa e spese di spedizione escluse.
Per conoscere le spese di spedizione inserire il prodotto nel carrello.
spacer
Casse Behringer Amplificate Attive